D-Link DWS-4000 Series, Cli Command Reference

Page: 115 / 566

107
DHCP Snooping Configuration Commands
no ip dhcp snooping binding
<mac-address>
Use this command to remove the DHCP static entry from the DHCP Snooping database.
ip verify binding
Use this command to configure static IP source guard (IPSG) entries.
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come. The default rate is 15 pps with a range
from 0 to 30 pps. The default burst level is 1 second with a range of 1 to 15 seconds.
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the burst level, to the defaults.
ip dhcp snooping log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP Snooping application.
Format
no ip dhcp snooping binding <mac-address>
Mode Global Config
Format
ip verify binding <mac-address> vlan <vlan id> <ip address> interface
<interface id>
Mode Global Config
Format
no ip verify binding <mac-address> vlan <vlan id> <ip address> interface
<interface id>
Mode Global Config
Default 15 pps for rate limiting and 1 sec for burst interval
Format
ip dhcp snooping limit {rate pps [burst interval seconds]}
Mode Interface Config
Format
no ip dhcp snooping limit
Mode Interface Config
Default disabled
Format
ip dhcp snooping log-invalid
Mode Interface Config