DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
86
Figure 7-41 ARP & FDB Table window
The fields that can be configured are described below:
Parameter
Description
Port
Select the port number to use for this configuration.
MAC Address
Enter the MAC address to use for this configuration.
IP Address
Enter the IP address the use for this configuration.
Click the
Find by Port
button to locate a specific entry based on the port number selected.
Click the
Find by MAC
button to locate a specific entry based on the MAC address entered.
Click the
Find by IP Address
button to locate a specific entry based on the IP address entered.
Click the
View All Entries
button to display all the existing entries.
Click the
Add to IP MAC Port Binding Table
to add the specific entry to the IMPB Entry Settings window.
L2 Multicast Control
IGMP Snooping
Internet Group Management Protocol (IGMP) snooping allows the Switch to recognize IGMP queries and reports
sent between network stations or devices and an IGMP host. When enabled for IGMP snooping, the Switch can
open or close a port to a specific device based on IGMP messages passing through the Switch.
IGMP Snooping Settings
In order to use IGMP Snooping it must first be enabled for the entire Switch under IGMP Global Settings at the top
of the window. You may then fine-tune the settings for each VLAN by clicking the corresponding
Edit
button. When
enabled for IGMP snooping, the Switch can open or close a port to a specific multicast group member based on
IGMP messages sent from the device to the IGMP host or vice versa. The Switch monitors IGMP messages and
discontinues forwarding multicast packets when there are no longer hosts requesting that they continue.
To view the following window, click
L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Settings
, as show below:
