D-Link DWS-1008 User Manual
1
Enabling the Auto-AP Profile
To enable the Auto-AP profile for automatic Distributed AP configuration, type the following command:
DWS-1008#
set dap auto mode enable
success: change accepted.
Specifying the Radio Profile Used by the Auto-AP Profile
The Auto-AP profile uses radio profile default by default. To use another radio profile instead, use the
following command:
set dap auto radio {1 | 2} radio-profile
name
mode {enable | disable}
The following command changes the Auto-AP profile to use radio profile autodap1 for radio 1:
DWS-1008#
set dap auto radio 1 radio-profile autodap1
success: change accepted.
Note: You must configure the radio profile before you can apply it to the Auto-AP profile.
Displaying Status Information for APs Configured by the Auto-AP
Profile
To display status information for APs configured by the Auto-AP profile, type the following command:
DWS-1008#
show dap status auto
Dap: 100 (auto), IP-addr: 10.8.255.6 (vlan ‘default’), AP model: DWL-8220AP,
manufacturer: D-Link, name: DAP100
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz
version=405GPr
id=
ram=33554432
s/n=0333703027 hw_rev=A3
Uptime:
18 hours, 36 minutes, 27 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 14
base mac: 00:0b:0e:00:d2:c0
bssid1:
00:0b:0e:00:d2:c0, ssid: public
bssid2:
00:0b:0e:00:d2:c2, ssid: employee-net
bssid3:
00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Summary of Contents for DWS-1008
Page 1: ......