DVX IPPBX
53 / 130
UDP Port
: SIP over UDP service port. By default D-Link IPPBX system uses UDP as SIP
transmission protocol. Port number can be changed here if required.
TCP Port
: By ticking the “
Enable
” checkbox you can enable global SIP TCP support.To register
a SIP extension over TCP protocol, you’ll have to select TCP transport on the extension
configure page, please refer to
chapter 2.8.1
.
TLS Port
: By ticking the “
Enable
” checkbox you can enable global SIP TLS support. To register
a SIP extension over TLS protocol, you’ll have to select TLS transport on the extension
configuration page, please refer to
chapter 2.8.1
.
Start RTP Port
/
End RTP Port
: The UDP ports used by DVX IPPBX system to carry RTP voice
stream.Do not change the port numbers or you may encounter audio issue with phone calls.
DTMF Mode
:The DTMF mode specifies how touch tones will be transmitted to the other
side of the call. Possible values for this field are rfc2833, inband, info, and auto.
Allow Guest
: This setting determines if anonymous callers are permitted to place calls to the
DVX IPPBX system. For security precautions please do not enable this option.
Max Registration/Subscription Time(sec)
: Maximum allowed time of incoming registrations
and subscriptions (seconds).
Min Registration/Subscrption Time(sec)
: Minimum length of registrations/subscriptions.
Default Incoming/Outgoing Registration Time(sec)
: Default length of incoming/outgoing
registration.
NAT Support
When the DVX IPPBX system is behind a NAT device and needs to communicate to the outside. It
needs to know whether it is talking to someone "inside" or "outside" of the NATted network. For
example, if you are going to deploy remote extensions you have to tell the DVX IPPBX system
which network address/addresses are from inside and which are from outside. Below is an
example configuration.
External IP
: Your static public IP address or domain name.
External Host
: This issimilarto“External IP”exceptthat the hostname is looked up every
"External Refresh" seconds(default 10’s).
External TCP Port
:Port number of SIP signaling with TCP transport protocol on the public
network.
External TLS Port
:Port number of SIP signaling with TLS transport protocol on the public
network.
