DVG-7022S/7044S/7062 User’s Manual
Network Settings
3-1 Network Settings (WAN)
The network settings are used to set the gateway’s communication ports, IP configurations, and Phone
Book Manager IP settings.
y
Current WAN IP Address
: The IP address of the WAN port.
y
Listen Port UDP
: It is not necessary to change the protocol of the communication port used by the
gateway, unless it conflicts with ports used by another device in your network.
y
RTP Starting Port UDP
: The initial value of the port number for transmitting voice data among
gateway(s). Each line requires 2 ports. For the
DVG-7022S/7044S/7062
gateway 8/16 UDP ports are
required. It is not necessary to change the setting, unless it conflicts with ports used by another
network device.
For example
, if the starting port is 9000, then Line 1 is using ports 9000 and 9001, and Line 2 is using
ports 9002 and 9003, and so forth.
IP Configuration (Setting WAN Port)
There are five methods of obtaining a WAN port IP address:
1. Static
IP
2.
DHCP, which means a Dynamic IP (Cable Modem)
3.
PPPoE (dial-up ADSL)
4. PPTP
5.
BigPond (for Australia only)
Methods for using DHCP and PPPoE for obtaining an IP address may vary. If you are not familiar with
creating a network connection, please contact your local ISP.
Setting Dynamic IP (DHCP)
Click “DHCP” to obtain a Dynamic IP address, enter the “Hostname” and “Vendor Class ID” if required by
your local ISP and then click the “Accept” button at the bottom of the screen.
Saving the settings: Click System Operation to select “Save Settings”, “Restart”, and then click the ”Accept”
button. Wait for about 40 seconds, and the system will obtain the required IP value from the DHCP Server.
Setting Static IP
Select “Static IP” and enter the IP address, Subnet Mask and Default Gateway values. Then click the
“Accept” button at the bottom of the screen. Save the settings, and then restart the system. Wait for about
40 seconds for the system to restart.
D-Link Systems, Inc.
8