Step 2:
Using the paperclip, press and hold the reset bu=on for more than ten seconds. The
power light on the front of the router will turn orange to indicate that the unit is restarQng.
Step 3:
The unit will reboot automaQcally. Once the Internet light stops blinking, the unit has
been reset and is ready to use. ReseTng the router does not reset the firmware to an earlier
version, but it will change all seTngs back to factory defaults.
Note:
The factory default username is Admin, and the password field should be led blank.
14.
How do I set up Website Filtering on my router?
Step 1: Open your Internet browser and enter h=p://dlinkrouter, h=p://dlinkrouter.local, or
h=p://192.168.0.1 into the address bar.
Step 2: Enter your login informaQon. If you have not changed the default seTngs, the
username is Admin and the password field should be led blank. Click
Login
.
Step 3: Click the Advanced tab at the top of the page then Website Filter from the menu at
the led-‐hand side of the screen. Select the opQon “Deny computers access to ONLY these
sites” from the
Configure Website Filter
drop-‐down menu. Type the website URLs to be
