88
Networking Basics
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. wireless
router) automatically. To verify your IP address, please follow the steps below.
Click on
Start
>
Run
. In the run box type
cmd
and click
OK.
(WindowsR 7/VistaR users type
cmd
in the
Start Search
box.)
At the prompt, type
ipconfig
and press
Enter
.
This will display the IP address, subnet mask, and the
default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings,
and the settings on your router. Some firewall software programs may
block a DHCP request on newly installed adapters.
Summary of Contents for DIR-822K
