DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
204
Click the
Find
button to locate a specific entry based on the information entered.
Click the
Show All
button to display all the entries.
RIPng
RIPng Settings
This window is used to display and configure the Routing Information Protocol Next Generation (RIPng) settings, also
known as IPv6 RIP.
To view the following window, click
L3 Features > RIPng > RIPng Settings
, as shown below:
Figure 6-202 RIPng Settings Window
The fields that can be configured in
RIPng Global Settings
are described below:
Parameter
Description
Global State
Select to globally enable or disable the RIPng feature here.
Click the
Apply
button to accept the changes made.
The fields that can be configured in
RIPng Settings
are described below:
Parameter
Description
Default Metric
Enter the default metric value here. The range is from 1 to 16. This value is
used to specify the default metric for routes redistributed from other routing
protocols. If the routes being redistributed are learned from other protocols,
then they have an incompatible metric with IPv6 RIP. Re-specifying of metric
allows the metric to be synced.
Select the
Default
option to use the default metric value, which is 0.
Distance
Enter the administrative distance for RIPng here. The range is from 1 to 254.
The distance value represents the trust rating of the route. The route with a
lower distance value is preferred over the route with the higher distance value.
Select the
Default
option to use the default administrative distance for RIPng,
which is 120.
Update Time
Enter the update interval value at which the update message is sent here. The
range is from 5 to 65535 seconds.
Summary of Contents for DGS-3130 Series
Page 1: ......
