4 Web-based Switch Configuration
D-Link DGS-2000 Series Ethernet Switch User Manual
7
7
1
1
Figure 4.89 - Configuration > Spanning Tree > MST Port Information
Instance ID:
Displays the MSTI ID of the instance being configured. An entry of
0
in this field denotes the
CIST (default MSTI).
Internal Path Cost (0=Auto):
This parameter is set to represent the relative cost of forwarding packets to
specified ports when an interface is selected within a STP instance. The default setting is
0
(auto).
0 (Auto) -
Selecting this parameter for the internal Cost will set quickest route automatically and
optimally for an interface. The default value is derived from the media speed of the interface.
Value 0-2000000 -
Selecting this parameter with a value in the range of
0
to
2000000
will set the
quickest route then a loop occurs. A lower internal cost represents a quicker transmission.
Priority:
Enter a value between
0
and
240
to set the priority for the port interface. A higher priority will
designate the interface to forward packets first. A lower number denotes a higher priorit
y.
Configuration > 802.3ah EthernetLink OAM > Ethernet OAM Port Settings
The Ethernet OAM Port Settings page allows user to configure the Ethernet OAM settings.
Figure 4.90 - Configuration > Ethernet OAM > Ethernet OAM Port Settings
From Port/To Port:
Select a range of ports to be configured.
Mode:
Use the drop-down menu to select to operate in either
Active
or
Passive
. The default mode is
Active
.
State:
Use the drop-down menu to enable or disable the OAM function.
Remote Loopback:
Specifies the Ethernet OAM remote loopback is None or Start.
None –
Select to disable the remote loopback.
Start –
Select to request the peer to change to the remote loopback mode.
Received Remote Loopback:
To configure the client to process or to ignore the received Ethernet OAM
remote loopback command.
Process –
Select to process the received Ethernet OAM remote loopback command.
Ignore –
Select to ignore the received Ethernet OAM remote loopback command.
Click
Apply
to make the configurations take effect.
Configuration > 802.3ah EthernetLink OAM > Ethernet OAM Event Configuration
The Ethernet OAM Event Configuration page allows user to configure the Ethernet OAM configuration
settings.
