DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
220
28
REBOOT SCHEDULE COMMANDS
The Reboot Schedule commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config reboot schedule
[in <value1-43200> | at <string 16> date <string 16>] {save_before_reboot [yes |
no]}
show reboot schedule
delete reboot schedule
Each command is listed in detail, as follows:
config reboot schedule
Purpose
Used to configure reboot time and save parameters for the reboot
schedule on the Switch.
There are three parameters setting here. Users can configure the
reboot time in two ways. The first way is to configure the reboot after
a specific interval time and the other way is to configure the reboot
at a specific date and time.
The third parameter determines whether to save the configuration or
not before the reboot. The reboot schedule won’t be saved to the
configuration file. After a reboot or shutdown, the reboot schedule
will be deleted automatically. Even when the system is saved by
using the
save
command, the configuration of the reboot schedule
also won't be saved.
Syntax
config reboot schedule [in <value1-43200> | at <string 16> date
<string 16>] {save_before_reboot [yes | no]}
Description
The
config reboot schedule
command is used to configure reboot
time and save parameters for the reboot schedule on the Switch.
Parameters
in <value 1-43200> -
Specify that the reboot will start after this time
interval has passed. Enter the time value, and this value must be
between 1 and 43200 minutes.
at –
Specify that the reboot will take place on the specified time and
date. If the date is not specified, the reboot takes place at the
specified time on the current day if the specified time is later than the
current time or on the next day if the specified time is earlier than the
current time.
<string 16> -
Enter the time with format hh:mm.
date <string 16> -
Enter the date with format ddmthyyyy.
save_before_reboot [yes | no] –
Specify that the device will first save
all configurations before initiating the reboot.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To reboot the device after 10 minutes and not to save the configuration before doing so:
