D-Link DGS-1100-06/ME, Cli Reference Manual

Page: 170 / 275

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
158
Restrictions Only administrator or operator
–level users can issue this command
Separate non
–consecutive Ethernet ports with a comma and no
spaces; use a hyphen to designate a range of ports. These ports are
defined as connected to a multicast router.
Example usage:
To configure mld mrouter ports:
DGS-1100-06/ME:5#config mld_snooping mrouter_ports vlanid 1 add 3,5
Command: config mld_snooping mrouter_ports vlanid 1 add 3,5
Success !
DGS-1100-06/ME:5#
config mld_snooping querier
Purpose Used to configure the timers and settings for the MLD snooping
querier for the Switch.
Syntax config mld_snooping querier [vlan_name <string 20> | vlanid
<vidlist> | all]
[last_listener_query_interval <sec 1-25> |
max_response_time <sec 10-25> | query_interval <sec 60-600> |
robustness_variable <value 2-255> | state [enable | disable] |
version <value 1-2>]
Description The config mld_snooping querier command allows users to
configure the time between general query transmissions, the
maximum time to wait for reports from listeners and the permitted
packet loss guaranteed by MLD snooping.
Parameters vlan_name <string 20>
–
Specifies that the mld snooping applies
only to this previously created VLAN.
vlanid <vidlist>
–
specifies that the mld snooping applies only to this
previously created VLAN id.
all
–
specifies that MLD snooping is to be configured for all VLANs
on the Switch.
last_listener_query_interval <sec 1-25>
–
The maximum amount of
time to be set between group-specific query messages. This interval
may be reduced to lower the amount of time it takes a router to
detect the loss of a last listener group. The user may set this interval
between 1 and 25 seconds with a default setting of 1 second.
max_response_time <sec 10-25>
–
The maximum time to wait for
reports from listeners. The user may specify a time between 1 and
25 seconds with a default setting of 10 seconds.
query_interval <sec 60-600>
–
Specifies the amount of time
between general query transmissions. The user may specify a time
between 1 and 65535 seconds with a default setting of 125 seconds.
robustness_variable <value 2-255>
–
Provides fine-tuning to allow
for expected packet loss on a subnet. The user may choose a value
between 1 and 255 with a default setting of 2. If a subnet is expected
to be lossy, the user may wish to increase this interval.
state [enable | disable]
–
Enabling the querier state will set the
Switch as a MLD querier and disabling it will set it as a Non-querier.
The default setting is disabled.
version <value 1-2>
–
Specify the version of MLD packet that will be
sent by this port. If a MLD packet received by the interface has a