D-Link DGS-1100-06/ME, Cli Reference Manual, Page: 160 / 275

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
148
configures the IGMP access authentication on the Switch.
Parameters
<portlist>
− A port or range of ports that will be configured as IGMP
access authentication ports.
all
− Specify all ports to be configured as IGMP access
authentication ports.
state[enable | disable]
− Specifies the state for the port to be
disabled or enabled.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure authentication port of IGMP:
DGS-1100-06/ME:5#config igmp access_authentication ports all state
enable
Command: config igmp access_authentication ports all state enable
Success !
DGS-1100-06/ME:5#
show igmp access_authentication ports
Purpose To display the IGMP access authentication configuration on the
Switch.
Syntax
show igmp access_authentication ports [<portlist> | all]
Description The
show igmp access_authentication
command displays the
IGMP access authentication configuration on the Switch.
Parameters all
− Specifies all ports to be displayed.
<portlist>
− A port or range of ports to be displayed on the Switch.
Restrictions None.
Example usage:
To display the IGMP access authentication:
DGS-1100-06/ME:5#show igmp access_authentication ports all
Command: show igmp access_authentication ports all
Port Authentication State
------ ----------------------------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
6 Disabled
DGS-1100-06/ME:5#