D-Link DGE-660TD User Manual
Troubleshooting
Confirming.the.Connection.(LED.Indicator)
When the notebook computer is powered “ON,” and the DGE-660TD is inserted into an open slot connector, please check the following
items if your LED light is not “ON.” When all items are working, your DGE-660TD’s direct port LED light should light up green (“linkage”
state.)
1. Make sure that your Ethernet Cat5 cable is in good working order.
2. Make sure that your hub or switch is powered “ON” and is functioning properly.
3. If the LED remains dark without any apparent cause, check the “Device Manager.” If there is an exclamation point next to the
DGE-660TD, then double-click to open. A message indicating the error will appear.
4. After verifying that the DGE-660TD has been installed correctly, check steps 1 and 2 again. If you continue to
encounter a problem, please call D-Link Technical Support for assistance.
Troubleshooting.the.Hardware.Installation
If you experience any problems with the hardware installation, first ascertain that all network cable connections are firm, that the proper
grade of cable is used for the network connection, and that the cable makeup is correct (straight without un-needed crossovers in the
connector wiring). Check that the supporting hub is powered-on and operating normally, and that the hub is properly qualified (under
100Base-TX and/or 1000Base-T standards).
Summary of Contents for DGE-660TD
Page 1: ......
