D-Link DAP-X1870 User Manual
32
Section 3 - Configuration
Network Settings
This page lets you configure the network settings for the
DAP-X18
7
0
. To access this page, click the
Settings
drop-down menu at
the top of the page, then select
Network
. Click
Save
at any time to save the changes you have made on this page.
Management Link
You can change the URL name of the device by editing the text
in the text box. If you change the name of the device, you will
need to enter “http://xxxx.local.” (where “xxxx” corresponds to
the name of the device) in the address bar of your web browser
in order to access the configuration utility.
Advanced Settings
The
Advanced
Settings
section
of
the
Network
Settings
page
allows
you to
configure
both
IPv4
and
IPv6
settings
that
will
be
used
by
the
DAP-
X18
7
0
’s
extended network.
IPv4
My LAN Connection is
Here you can select whether you want the IP to have a
Dynamic IP
or
Static IP
address. If you select Dynamic IP, the
options below will not be available.
IP Address
Enter the Static IP address that you want to assign to the
extended network AP. This address should be outside of the
uplink router’s DHCP address pool.
Subnet Mask
Enter the subnet mask.
Gateway Address
Enter the gateway address. This is usually the IP address of
the uplink router.
Primary DNS Server
Enter the address of the primary DNS server.
Secondary DNS Server
Enter the address of the secondary DNS server. This is optional
but will provide backup if the primary server fails.