DAP-600P
Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
IPv6
Go to the
IPv6
tab to change or add the IPv6 address of the access point, configure IPv6 addresses
assignment settings, specify MAC address and IPv6 address pairs, or add own DNS records.
Figure 70. Configuring the local interface. The
IPv6
tab. The
Local IPv6 Address
section.
To add an IPv6 address of the access point, click the
ADD
button (
). To change the IPv6
address of the access point, select it in the table.
Figure 71. Configuring the local interface. The
IPv6
tab. The window for adding an IPv6 address.
In the opened window, you can specify the following parameters:
Local IPv6 Address
IPv6 address
The IPv6 address of the access point in the local subnet. By default,
the following value is specified:
fd00::1
.
Prefix
The length of the prefix subnet. By default, the value
64
is
specified.
Gateway IPv6 address
Available if the
Access point
or
Repeater
mode was selected in
the Initial Configuration Wizard.
The gateway IPv6 address which is used by the access point to
connect to the Internet (e.g., for synchronizing the system time with
an NTP server).
Optional
.
Click the
APPLY
button.
To remove the IPv6 address, select it in the table and click the
DELETE
button in the opened
window. Then click the
APPLY
button.
Page
85
of 235
