DAP-600P
Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
MAC Filter
On the
Advanced / MAC Filter
page, you can configure MAC-address-based filtering for
computers of the access point's LAN. This page is also available in the
Firewall
section if the
Router
or
WISP Repeater
mode was selected in the Initial Configuration Wizard.
Figure 119. The
Advanced / MAC Filter
page.
Select the needed action from the
Default mode
drop-down list to configure filtering for all
devices of the access point's network:
•
Allow
: Allows access to the access point's network and to the Internet for devices (the value
is specified by default);
•
Deny
: Blocks access to the access point's network for devices.
!
You can use the
Deny
mode only if an active rule which allows access to the device's
network is created on the page.
To create a rule (specify a MAC address of a device for which a special filtering mode will be
applied), click the
ADD
button
(
)
.
Figure 120. The window for adding a rule for the MAC filter.
Page
157
of 235
