DAP-300P
Wireless N300 PoE Access Point / Router
User Manual
Installation and Connection
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (configure the wireless network, change the operating mode of the device,
specify the settings of the firewall, etc.).
Start a web browser (see the
section, page 14). In the address bar of the web
browser, enter the IP address of the access point (by default,
192.168.0.50
). Press the
Enter
key.
Figure 25. Connecting to the web-based interface of the DAP-300P device.
!
If the error “
The page cannot be displayed
” (or “
Unable to display the page
”/“
Could not
connect to remote server
”) occurs upon connecting to the web-based interface of the
access
point
, make sure that you have properly connected the
access point
to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the
Figure 26. The page for running the Initial Configuration Wizard.
Page
36
of 175
