DAP-300P
Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
UPnP IGD
This page is available if the
Router
or
WISP Repeater
mode was selected in the Initial
Configuration Wizard.
On the
Advanced / UPnP
IGD
page, you can enable the UPnP IGD protocol. The access point
uses the UPnP IGD protocol for automatic configuration of its parameters for network applications
requiring an incoming connection to the access point.
Figure 114. The
Advanced / UPnP IGD
page.
If you want to manually specify all parameters needed for network applications, move the
Enable
switch to the left. Then go to the
Firewall / Virtual Servers
page and specify needed settings.
If you want to enable the UPnP IGD protocol in the access point, move the
Enable
switch to the
right.
When the protocol is enabled, the access point's parameters configured automatically are displayed
on the page:
Parameter
Description
Protocol
A protocol for network packet transmission.
IP address
The IP address of a client from the local area network.
Private port
A port of a client's IP address to which traffic is directed from a
public port of the access point.
Public port
A public port of the access point from which traffic is directed to a
client's IP address.
Description
Information transmitted by a client's network application.
Page
136
of 175
