DAP-1360
Wireless N300 Access Point & Router
User Manual
Configuring Device (Router Mode)
Routing
On the
Advanced / Routing
page, you can add static routes (routes for networks that are not
connected directly to the device but are available through the interfaces of the device) into the
system.
Figure 186. The
Advanced / Routing
page.
To create a new route, click the
Add
button. In the line displayed, you can specify the following
parameters:
Parameter
Description
Destination network
A destination network to which this route is assigned.
Destination netmask
The destination network mask.
Gateway
An IP address through which the destination network can be accessed.
The field is available when the
<Auto>
value is selected from the
Via
Interface
drop-down list of this line.
Metric
A metric for the route. The lower the value, the higher is the route
priority.
Optional
.
Via Interface
Select an interface through which the destination network can be
accessed from the drop-down list. If you have selected the
<Auto>
value of this drop-down list, the access point itself sets the interface on
the basis of data on connected networks.
After specifying the needed parameters, click the
Apply
button.
Page
239
of 270
