11
Web Configuration
If you are incorporating the DWL-G810 into a network that contains all D-Link
devices, you do not need to use the Web Configuration utility. With its default
settings, the DWL-G810 will connect with other D-Link 802.11b or 802.11g devices
that are set to their default settings, with no configuration needed!
If your network contains devices other than D-Link devices, or if you wish to configure
the DWL-G810, you will need to do the following before using the Web Configuration
Utility:
Requirements for using the DWL-G810’s Web
Configuration Utility
You will need a JavaScript-enabled web-browser such as the Internet Ex-
plorer 6.0 or later, or the Netscape Navigator 6.0 or later.
The computer that you are using for initial configuration must have an IP
address within the same range as the IP address of the DWL-G810. The
DWL-G810 has a default IP address of
192.168.0.30
with a subnet mask of
255.255.255.0
You will need to assign a static IP address to the computer that you are
using to configure the DWL-G810, within the IP address range of the
DWL-G810. For example, you can assign a static IP address of 192.168.0.2
with a subnet mask of 255.255.255.0 to the computer you will use for
configuration. (Please refer to the Appendix section of the Quick Installation
Guide.)
Factory Default Settings for the DWL-G810
Operating Mode:
Infrastructure
SSID:
default
Channel:
6
Transmission rates:
Auto
Encryption:
Blank (no password needed)
Administrator Password:
No
IP Address Mode:
Static
IP Address:
IP Subnet:
username:
admin
255.255.255.0
192.168.0.30
