ROBOT . HEAD to TOE
Product User’s Manual –
Shield-Servo
4.BOARD LAYOUT
Label
Function
Label
Function
A
UART selector
F
Push button to reset
B
Connector for Servo motor
G
Push button to test
C
Servo motor power indicator
(1 LED)
H
Small green LED as VCC indicator
D
Manufacturing test point
I
Power input source for servos
E
UC00A/UC00C communication
J
Connector to Arduino (Signal)
K
Solder if use internal power
A
A DIP switch used to select TX and RX pin for Shield-Servo.
B
An 8 ways connector for user to connect particular Servo motor. Please insert the
wire properly by referring to chapter 5,
.
C
A LED acting as indicator for Servo Power. This LED will indicate that Servo is being
powered.
.
D
Manufacturing test point for Shield-Servo. The header pin is not soldered since it is
meant for production test point. Please DO NOT connect or shorted any of these pins.
Created by Cytron Technologies Sdn. Bhd. – All Rights Reserved
8
