Product User’s Manual –
6.0 MOTOR CONNECTION
Similar to the power supply, connection to the motor can be made either via the terminal
block, or it can be soldered directly to the bottom layer pad.
NOTE:
For application where the current is > 20A, it’s recommended to solder the wire directly to
the pad at bottom layer.
Steps to connect the motor via terminal block:
1.
Open the cover for terminal block.
2.
Remove the screw from the terminal block.
3.
Wrap the wire of DC motor around the screw.
Created by Cytron Technologies Sdn. Bhd. – All Rights Reserved
15
