6.3
Regular maintenance
The following list describes general user maintenance activities.
•
Replace the fuse in case of fuse failure. See
Section 6.4 Replacement of fuses, on
for more information.
•
Handle and store the tube holders in a safe designated place. Dropping the holders
on the pin side could cause damage to holder and result in poor fit.
•
Before use, check whether the code plate underneath the left tube holder is intact.
•
Tighten the captive screw, if the installed tube holders are found to be slack.
•
Clean the instrument surface, welding region, and tube holders from any liquid
spillage after tube welding operation.
•
Perform safety checks on instrument and surroundings at regular intervals, once in
a quarter for safe operating conditions.
•
Contact Service to schedule the instrument for preventive maintenance by Cytiva
service personnel.
All other maintenance tasks on Sterile Tube Fuser - Wet must be performed by a Cytiva
Service representative.
6 Maintenance
6.3 Regular maintenance
60
Sterile Tube Fuser - Wet Operating Instructions 29024010 AD
