WICED Manufacturing Bluetooth Test Tool, Document Number: 002-14799 Rev. *E
16
11
BQB RF Test
This test issues the commands necessary to configure the Cypress SoC BT device into a test mode for BQB RF testing using
a Bluetooth tester, see BQB RF Test Setup [3].
Usage
:
wmbt enable_bqb_test_mode COMx
Before executing this command to configure the device for test mode, you must ensure you application does not have any
timers running or any over the air BT activity enabled. For example, if advertisements are enabled or a periodic application
timer is enabled, it may be possible to interfere with the BQB test results.
Example
:
<ModusToolbox>\tools\wiced-tools-1.0\BT\wmbt\bin
>
wmbt enable_bqb_test_mode COM23
MBT_BAUD_RATE: 3000000
TRANSPORT_MODE: 0 (HCI)
Opened COM23 at speed: 3000000
Sending HCI Command:
0000 < 01 05 0C 03 02 00 02 >
Received HCI Event:
0000 < 04 0E 04 01 05 0C 00 >
Success
Close Serial Bus
Opened COM23 at speed: 3000000
Sending HCI Command:
0000 < 01 1A 0C 01 03 >
Received HCI Event:
0000 < 04 0E 04 01 1A 0C 00 >
Success
Close Serial Bus
Opened COM23 at speed: 3000000
Sending HCI Command:
0000 < 01 03 18 00 >
Received HCI Event:
0000 < 04 0E 04 01 03 18 00 >
Success
Close Serial Bus
