CYALKIT-E02 Solar-Powered BLE Sensor Beacon Reference Design Kit Guide, Doc. No. 002-11317 Rev. *C
19
6. Start installing the USB driver. Click the
Close
button when the KitProg USB-UART driver installation finishes.
7.
After successful device driver installation, confirm that a new COM port called
“KitProg USB-UART” was added:
A. Open the
Device Manager
.
B. Under
Ports (COM & LPT),
confirm that a COM port called
“KitProg USB-UART” was added.
Note the COM number (COMxx).
3.1.3 Establishing BLE Connection
1. Set the slide switch (SW1) on the Solar BLE Sensor to Demo mode (DM). Refer to
5.1.4.1 Waveform of Demo Mode and
for detailed information on each mode.
Note:
Use the sharp end of something like tweezers (not included in the kit) to change the mode.
Demo Mode
(DM)
Timer Mode
(TM)
SW1
