CY8CKIT-015 PSoC 1 Power Supervision Kit Guide, Doc. # 001-81218 Rev. **
11
3.
Example Project
The PSoC 1 Power Supervision Kit includes the CY8CKIT_015_Example_Project. This section pro-
vides instructions to run the example project.
3.1
Running the Example Firmware
1. Make sure the hardware is configured according to
.
2. If this is the first time that the example project firmware is being programmed into PSoC 1, make
sure the EBK is not connected to the PSoC DVK.
3. Connect the MiniProg3 first to a USB port on the PC and then to the PROG port on the CY8CKIT-
020 (CY8C28 Family processor module).
4. Open PSoC Programmer; connect to the MiniProg3 by clicking on the MiniProg3 device ID that
appears in the Port Selection tab.
5. Browse to the hex file located in the firmware section of the CD contents; load the file using the
File Load
option; turn on
AutoDetection
; and select
Power Cycle
programming mode.
6. Select
ISSP
programming protocol and
5.0 V
programming voltage.
Figure 3-1. PSoC Programmer
7. Click on the
Program
tab to start programming.
8. Remove MiniProg3 from the DVK and attach the EBK to port A of the DVK.
9. On the EBK, make sure the power jumper (J5) is set to
DVK
(default setting).
Summary of Contents for CY8CKIT-015
Page 10: ...10 CY8CKIT 015 PSoC 1 Power Supervision Kit Guide Doc 001 81218 Rev Getting Started...
Page 24: ...24 CY8CKIT 015 PSoC 1 Power Supervision Kit Guide Doc 001 81218 Rev Example Project...
Page 33: ...CY8CKIT 015 PSoC 1 Power Supervision Kit Guide Doc 001 81218 Rev 33 A 3 5 Top Silkscreen...
Page 36: ...36 CY8CKIT 015 PSoC 1 Power Supervision Kit Guide Doc 001 81218 Rev...
