CY4541 EZ-PD
TM
CCG4 EVK
QUICK START GUIDE
STEP
1
STEP
2
Unpack the kit contents
Note: Color of the solder mask used on CCG EVK base boards and CY4541 CCG4 daughter card
may vary from the image shown in step1.
Jumper Wire
USB 2.0 Type-A
to Mini-B Cable
USB 3.0 EMCA Type-C Cable
USB 3.0 Type-A
to Type-B Cables
24V DC Power Adapter
Screwdriver
USB Type-C to
Type-A Adapters
Verify that the user LED jumper (J11) is populated on CCG EVK base board 1 (connected to Port 1of
CCG4 daughter card) and that the voltage selection jumper (J5) on the CCG4 daughter card is set to
3.3 V (position 1-2). Ensure that the wires are connected with correct polarity between the power
provider header (J12) of both the CCG EVK base boards as shown in the figure in step2. Connect the
DC power adapter (provided with the kit) to the DC power jack (J1) of either of the CCG EVK base
boards.Verify that the setup is as shown in the figure in step2. Plug the other end of the DC power
adapter to the AC power socket. LED1 (Green) on the CCG4 daughter card and on both the CCG EVK
base boards glow to indicate that the kit is powered. In addition, the LED2 (Orange) on the CCG EVK
base board 1 blinks continuously to indicate that CCG4 is powered and active.
J5
J11
LED1
(on CCG4
Daughter Card)
Port 1
J12
J1
Red color wire to the
+ve terminal
LED1 (on CCG
EVK Base Board 1)
LED2 (on CCG
EVK Base Board 1)
LED1(on CCG EVK Base Board 2)
CCG
EVK Base Board 1
CCG EVK Base Board 2
CY4541 CCG4
Daughter Card
J12
J1
Red color wire to the
+ve terminal
+
+
DC Power Adapter
Connected to CCG
EVK Base Board 1
Note: Ensure that CCG4 daughter
card is firmly connected to the
CCG EVK base boards.
CCG EVK
Base Board
CCG EVK
Base Board
CY4541 CCG4
Daughter Card
