CynkoMet T-169/1, Instructions For Use And Operation

Page: 74 / 144

Cynko Met
T-169
Page
74
If, for maintenance tasks, raising the crate is necessary, it
should be tipped aside and secured before reclining the
support of the loading crate (fig.16 p.1).
In the frame of container, there are sockets of the crate
support (fig.16 p.2). The crate should be lifted by a hydraulic
cylinder, then paying particular attention to safety, raise the
crate support and slowly lower the loading crate direct the
support to the socket.
The loading crate cannot be loaded. The trailer must be
connected to the tractor and secured with chocks and locked
with a parking brake.
6.1 Regulation of driving wheel bearings
backlash.
In a newly purchased machine, after the first 100 km, while
during further use - after driving another 1500- 2000 km - check
and if necessary adjust the backlash of the wheel bearings. To do
this you need to:
 Connect the trailer to the tractor, set such a set on a hard surface
in the direction of driving straight ahead (front axle of the trailer
may not be twisted)
 Brake the trailer.

Place the blocking wedges under the wheels of a trailer, raise the
trailer wheel on the opposite side of the wedges so that the wheel
does not touch the ground and secure it from falling.

Check the backlash:

By turning the wheel slowly in both directions, check
that movement is smooth, and if the wheel rotates
without excessive resistance and jams

Spinning the wheel so that rotates very quickly, check
that the bearings do not make unnatural sounds.