CynkoMet N-221/3-3, Instructions For Use And Operation, Page: 72 / 119

Cynko Met N-221/3-3
N-221/4-3
72
7. Transport
The spreader is prepared for sale in a complete state and does not
require packing. The instruction manual of the machine and the cable
connecting the electrical system, the PTO shaft only undergo packaging.
The supply of the spreader to the user is done by independent
transport after connecting with the tractor or automobile (in this case, the
spreader because of the height can be mounted on the platform of the
transport mean on the hubs - with unscrewed and taken off wheels or on
wheels, but with disassembled and folded upper extensions.
Loading and unloading of a spreader from a car should be carried out
using the loading ramp with an agricultural tractor or using a crane, lever.
During operation, observe the general safety rules with handling operations.
Persons operating the reloading equipment must have the required
permissions to use these devices.
When loading / unloading using the tractor, the spreader must be
properly connected with the tractor according to the requirements contained
in this manual. The spreader braking system must be running and tested
before running off or driving on the ramp.
When loading / unloading using a crane or a lever, the spreader is to
be lifted with the help of approved fasteners designed to carry the load with
sufficient capacity. The belts must be in good condition, they cannot show
any signs of damage.
The belts should be placed under the lower frame of the spreader in
such places that when lifting the machine the belts do not have the possibility
of moving, and the spreader when moving is not tilting. If there is a possibility
of damage or frayed belts against components of the machine, put washers
in sensitive areas.
In order to avoid compression of the walls to the inside the spreader,
when loading with the use of a crane, use a special traverse, where the places
of hooking the belts will be spaced wider than the total width of the machine.
The spreader should be attached firmly to the platform of the transport
mean with belts, chains, lashing or other fastening means equipped with a