CynkoMet N-221/3-3, Instructions For Use And Operation

Page: 28 / 119

Cynko Met N-221/3-3
N-221/4-3
28
The upper frame consists of longitudinal stringers and crossbars. On the
upper frame, a floor panel of sheet metal having a thickness of 4 mm is
attached by means of screws and rivets Side walls with a height of 0.8m are
screwed to the frame. There is a possibility in this type of spreader, after
demounting the adapter and adding a rear wall (opening hydraulically) of
extensions with a height of 0.75m, which increases the load platform to 14m3.
The basic loading crate, without extensions is finished with a hydraulic wall
(stringer) moving along the tracks located on the side walls. The stringer at its
end on one side is equipped with a thick rubber with recesses profiled on the
conveyor chain, which is stopped by a half liquid material placed on the load
crate during operation.
4.2.4 Adapter
The adapter consists of a frame bolted from the profiled sheets. In the frame,
there are 4 drums with a diameter of 450 mm, on which cutting knives are
welded to the worms. The drums are moved by the drive of the gearbox. The
adapter is also equipped with a protective guard, raised simultaneously with
the rear hydraulic wall.