Cynko
Met
N-200
Page 10
NOTE!
NOTE!
The operation and exploitation of the machine not in accordance
with the Instruction Manual releases the Manufacturer from
liability for the consequences resulting from non-compliance with
the provisions contained therein. At the same time, it causes a loss
of warranty.
NOTE!
NOTE!
The manufacturer is not responsible for changes made by the user
in the design of the spreader, and such changes will void the
warranty.
3.
Safety in use
3.1
General safety and accident prevention regulations
Before using the spreader, you should carefully read the contents of the
manual. During operation, observe all instructions contained in the manual.
Before every start-up, the spreader must be checked for safety of operation
(completeness of all guards, fastening of all screws (table 6)), whether there
are cracks or visible damage on the structure, chain tension “not too loose” is
checked by lifting the chain up by the central strip (the space between the
floor panel and strip should be about 3 cm), and the condition of the ball
hitch).
Climbing onto the spreader is prohibited.
The spreader can be coupled to vehicles equipped with a ball hitch designed
for coupling with the BC-1200M hitch. It is strictly prohibited to tow the
spreader with a passenger car. Pay attention to the warnings in places of
crushing and shearing when starting the machine and all the pictograms
placed on the spreader.
The speed of driving must always be adapted to the environmental
conditions. Avoid travel over ditches and avoid sudden turns.
When coupling and decoupling the mini-spreader to/from the driving
