2.1.2.2 Admin Code Setting
Admin code is used to enter administrator interface. The default code is 2396. Enter
Admin Code Setting to input 4 digit new admin codes, click Dial key
to save.
2.1.2.3 Service Code Setting
Service Code Setting is used to enter user interface. The default code is 3888. Enter
service code setting to input 4 digit new user codes, click Dial key
to save.
2.1.3 System Setting
2.1.3.1 Network settings
Enter System Setting interface ,press 1 to enter Network setting. Select DHCP mode ,
door phone will access network automatically. Choose Static mode, user need to
setup IP address, subnet mask and default gateway. Press Dial key
when you
finish each step.
2.1.3.2 Station No.Settings
User can setup the device ID to limit the unlock permissions.
(This function can not be used now. Cygnus will perfect it in next version )
2.1.3.3 Restore default
Enter System setting , press 3 to enter restore interface. After you sure to make the
device restore to factory setting, swipe you admin card or enter admin code, then
the device will restore.
Manual de usuario
VTX-300
cygnus.la
9
