Rock Box™ Installation Instructions
Parts List:
(1) Rock Box All-in-One Audio Source
(1) Power Harness with Quick Disconnect
(1) Red T-Tap Wire Connector
(1) Blue T-Tap Insert Wire Connector
(1) Ground Ring Terminal Connector
(4) Plastic 1/4” Spacers
(4) 8-32 x 1/2” Screws
Before installing your unit read all instructions carefully and
completely to avoid damage to your equipment. Also, decide
your mounting location before routing wires to ensure an easy
installation.
Power Connections:
1. Locate the
accessory power wire
on your vehicle using a
voltmeter or test light. You must use an accessory power
wire because the Rock Box should only receive power when
the vehicle is turned on to avoid draining your battery
when not in use. Consult your factory service manual or
maintenance technician for more information on locating
the accessory power wire on your particular vehicle.
2. Before making any wire connections
disconnect the
vehicle’s battery
and route the power harness wires from
the connection location(s) (power/ground) to the desired
Rock Box location on your vehicle. Make sure to
keep wires
away from high temperature areas
such as exhaust pipes,
engine covers and motor heads.
3. Once you have located the accessory power wire on your
vehicle and routed the power harness wires, attach the
supplied
Red T-Tap Wire Connector
to the
accessory wire
on the vehicle. Then attach the supplied
Blue T-Tap Insert
onto the
red wire of the power harness
and connect the
two T-Tap pieces.
4. Connect the black wire on the Rock Box power harness to
