Cyclades AlterPath ACS, Command Reference Manual

Page: 43 / 420

AlterPath ACS Command Reference Guide
27
Device Access
How to close the session from ts_menu (from the console of your unit)
To close the session from the ts_menu , follow the steps bellow:
Step 1 - Enter the escape character.
The escape character is shown when you first connect to the port. In
character/text Mode, the Escape character is ^]
After entering the escape character, the following is shown:
Console escape. Commands are:
•
l - go to line mode
•
c - go to character mode
•
z - suspend telnet
•
b - send break
•
t - toggle binary
•
e - exit telnet
Step 2 - Press “e” to exit from the session and return to the original menu.
Select the exit option and you will return to the shell prompt.
How to close the session from ts_menu (from a Telnet/SSH session to your unit)
You have to be sure that a different escape character is used for exiting your Telnet/SSH
session; otherwise, if you were to exit from the session created through the
ts_menu , you
will close your entire Telnet session to your unit. To do this, when you first Telnet/SSH
to your unit, use the -e option. So for example, to set Ctrl-? as the escape character, type:
# telnet -e ^? 192.168.160.10
# ssh -e ^? user1@192.168.160.10
To exit from the session created through the ts_menu , just follow Step 1 from above.
To exit from the entire Telnet session to your unit, type the escape character you had set.
To exit from the entire SSH session to your unit, type the escape character you had set
plus character "."(dot).
To close an SSH session the escape character followed by a “.” must be entered at the
beginning of a line.
CLI Mode - ts_menu
You can call ts_menu from the CLI interface.