AlterPath ACS Command Reference Guide
313
Profile Configuration
The following parameters are specific to the Bidirectional
Telnet in the
/etc/portslave/pslave.conf
file.
Table 8.5: Bidirectional Telnet specific parameters for pslave.conf
See ‘CAS specific parameters for the pslave.conf” on
page 299, and ‘TS specific parameters for the pslave.conf file”
on page 309 for the respective parameters.
To configure Bidirectional Telnet
CLI Method
Follow the below steps to configure Bidirectional Telnet protocol.
Step 1 - Open the CLI interface by issuing the command:
# CLI
Step 2 - Activate bidirectional Telnet
cli> config physicalports <'all' or range/list[1-4]> general protocol
<protocolname>
Step 3 - To specify a login timeout
cli> config physicalports <'all' or range/list[1-4]> access logintimeout
<login timeout in seconds>
Parameter
Description
Example
sxx.protocol
The connection protocol for the
specified serial port.
s1.protocol bidirect
sxx.authtype
The authentication method configured
for the serial port.
s1.authtype local
sxx.logintimeout
The time (in seconds) for the serial port
to return to idle state, if the user does not
login.
s1.logintimeout 60
sxx.sh
The shell command used to present a
menu to the user.
s1.sh /bin/menush
“xx”
represents the serial port number being configured.
Summary of Contents for AlterPath ACS
