Please read the manual carefully to ensure the proper use of your new bike light.
You can also download the manual from our website : www.cycartis.com
For LED lights that conform to German traffic regulation StVZO, there is label marked on
the package and a StVZO No. on each LED light.
For LED lights that don’t conform to German traffic regulation StVZO, there is no label
marked on the package and StVZO No. on each LED light.
ALFA REAR
CONTENTS
Bike Light, Silicone Strap, Micro USB cable, and Silicone
Pad
MOUNTING
Securely attach the hook on the rear of the light with one
side of silicone strap and the mount on the seat post or
seat stays. The silicone strap is able to fit the diameter of
seat-post from the 18mm to 48mm range and other types
of seat posts e.g. aerodynamic seat post.
Fig. 1: Mount on seat post
Fig. 3 : Mount on aero seat post
around tube
Enlarge the gap of
the silicone pad
Fig. 2: Mount on seat stay
(The silicone pad must be
reversely replaced)
BATTERY INDICATOR
While the LED light is turned ON, the battery capacity will
use a signal light to show its current status immediately.
80%
↑
30% - 80%
ORANGE
GREEN
30%
↓
RED
* Please always charge the LED light fully before using
it for the first time.
* Before the storage, please charge the LED light to green
battery indicator (Full Charge).
* During storage, please keep the battery in a cool and
dry place.
* Please recharge the battery at least every 3 months.
* If the moisture has occurred in the LED light, please
open the rubber case of USB port and air dry the battery.
* Please do not charge over 5V/500mAh as this will
damage the battery.
* Please unplug the LED light right away while it is fully
charged.
* The battery capacity may become ineffective to about
80% of its value after 300 recharge cycles.
BATTERY MAINTENANCE
!
* If the LED light turns out due to a low battery capacity
during the ride, it is recommended that saving the
battery by using the flash mode or recharging the light
with the a portable power bank. In this case, the battery
indicator will still show constant red and yet it will
operate in this mode. We cannot guarantee water
protection while both operating and charging the light
at the same time during rainy or wet conditions.
* Please switch to the Day Time Mode (Slow-Flashing) to
increase visibility and safety during the day time.
* Battery runtime and charging time may vary depending
on the operational environment the light is in and the
conditions under which it is being used.
NOTE
!
CHARGING
Fully charge the battery before using the LED Light for
the first time.
1. Switch off the LED light.
2. Open the rubber case of Micro USB port and plug it in
with a Micro USB cable.
3. Also plug into the powered USB port on the laptop or
wall. The charging indicator will turn on immediately.
4. Unplug the Micro USB cable after a full-charge. The
charging time is estimated to be around 2-3hours.
Charging
Fully Charged
GREEN
RED
