2.
Press
or
to select language.
Description
Option
English, Français or Español.
ATSC choices
English, Français, Español, Dutch, Danish, Russian, German, and Swedish.
DVB-T choices
3.
Press the
SETUP
button to return to
SETUP MODE
menu.
Exit Set Up Mode by pressing the
SETUP
button.
Setup Complete
Testing operation
Use the following instructions to test the full resistance range of the unit:
1.
Plug the optional power cord into a power outlet from a grounded circuit, See
Electrical
Requirements
.
Coil up the remainder of the power cord and place it out of the way. If you do not have the optional
power supply, skip to step 3.
2.
Verify the control panel will illuminate and is in
Dormant Mode
.
3.
Hold the handrails to steady self while stepping into the pedals.
4.
Begin pedaling.
5.
Press the
Quick Start
key.
6.
Run unit through full resistance range.
First press the
RESI
key until unit reaches its highest load (the display will show “21”).
Then press the
RESISTANCE -
key until unit reaches its lowest load (the display will show “1”). The
resistance should increase and decrease while pedaling.
When unit reaches the set resistance, the displays will stop flashing and remain steadily illuminated
to indicate the desired setting has been reached.
7.
Wait until pedals come to a complete stop before dismounting the unit.
Hold the handrails to steady self while stepping off the unit.
Page 46 of 80
Cybex 525C/525R Cycle Part Number LT-24303-4 E
