CPS600E
Copyright © 2010 CyberPower Systems, Inc.
4
INSTALLING YOUR EPS
UNPACKING
Inspect the EPS upon receipt. The box should contain the following:
EPS unit x 1; User manual x 1; Input Power Cord x 1; DC Fuse x 2
AUTOMATIC VOLTAGE REGULATOR
Utility power is inconsistent.
The
EPS increases low voltage to computer safe 220 volts. The
EPS
automatically provides battery backup (External battery connection required) if the voltage drops below
170 volts or exceeds 270 volts.
HARDWARE INSTALLATION GUIDE
1. Your new EPS may be used immediately upon receipt. However, recharging the external battery for at
least 8 hours is recommended to ensure that the battery’s maximum charge capacity is achieved. To
recharge the external battery, simply leave the unit plugged into an AC outlet when EPS is ON.
2.
DO NOT use with medical or life support equipment. DO NOT use with or near aquariums as
condensation may cause the unit to short out.
3. After connecting the hard wires, plug the EPS into a 2 pole, 3 wire grounded receptacle (wall outlet).
Make sure the wall branch outlet is protected by a fuse or circuit breaker and does not service
equipment with large electrical demands (e.g. air conditioner, copier, etc…). The warranty prohibits the
use of extension cords, outlet strips, and surge strips.
4. Press the power switch to turn the unit on. The power on indicator light will illuminate and the unit will
beep once.
5. If an overload is detected, an audible alarm will sound and the unit will emit one long beep. To correct
this, turn the EPS off and unplug the equipment from the AC outlet. Ensure that the equipment plugged
into the outlet does not exceed the UPS unit’s rated capacity (600VA/420W for CPS600E).
If the
rated capacities of the unit are exceeded, an overload condition may occur and cause the UPS unit to
shut down or the input fuse to blow. For more information, refer to the “Troubleshooting” section.
6. To maintain optimum battery charge performance, make the EPS plugged into an AC outlet at all
times.
7. The UPS is designed for horizontal or wall-mount use only. To ensure safety, please follow the
placement directions as shown below.
