CPS600E
Copyright © 2010 CyberPower Systems, Inc.
10
FAULT WARNING DISPLAY AND ALARM
1.
Overheat Protection:
The EPS output will be interrupted. After 30 seconds, the machine shuts
down and the LCD display output voltage is zero.
2.
Over-Load Protection
：
：
：
：
The EPS output will be interrupted. After 30 seconds, the machine shuts
down and Over Load Icon lights on the LCD display.
3.
Battery Missing
：
：
：
：
You should hear a long beep and Battery Indicator flashes
。
4.
Low Battery Protection:
The EPS output will be interrupted. After 30 seconds, the machine shuts
down and the LCD display output voltage is zero.
5.
The following table shows each corresponding warning message on the LCD display and the alarm
reacts during the machine shut down
：
LCD
Warning
Display
Alarm
Condition
Solution
Over Load Icon
Constant tone
Over Load Output-Off - Load
exceed the rating of EPS.
Check total load to
confirm the rating of
EPS.
Zero Output
Voltage
Constant tone
High Temperature Output-Off
Check fans function and
air vent clearances.
Low Battery Output-Off
-- Insufficient battery capacity.
Recharge the battery.
Over Charge or AVR Error--
In Line Mode, battery is
overcharged or AVR is faulty.
Inform service agents.
Short Output-Off -- Output
Short Circuit Protection
Check the EPS output
to see if there is a short
circuit.
Can Not Start Up
None
Line Input/ Output Error
Output-Off -- incorrect Input/
Output connection
Check Input/ Output
connection.
Cold
Start
Battery
High
Voltage Output-Off -- the
battery voltage is too high
during cold start.
Check the reason for
battery over-voltage.
