CyberOptics SE500ULTRA, Hardware Manual

Page: 165 / 188

CyberOptics Corporation 155
System Error Messages
System Error Messages
The System tab on the Output palette displays any hardware-related messages and errors
resulting from copying or clearing system files. These messages may help you troubleshoot
problems related to the hardware or the internal software. The messages in this tab are retained
until you shut down system power.
The SE500
ULTRA
uses a unique 5-digit error code to distinguish between different types of
errors and help in identifying the corresponding location from where the problem was reported.
The messages displayed in the Output palette are simplified versions of the error messages. You
can view complete information about the error message(s) in the MachineControl.log file located
in the xfer directory. This log file provides sufficient information to diagnose the problem or
report the problem to CyberOptics Service and Support for further analysis. You can configure
the logging options under Tools>Options>Advanced tab to record additional information in the
MachineControl.log file. See the
Solder Paste Inspection Online Help for details on the different
logging options.
System Error Message Format
System error message are displayed in the following format:
<date><time><Legacy Code><Error Description>(<Module>:<EID_number>)
where:
●
<date>: Date on which the error occurred.
●
<time>: Time at which the error occurred.
●
<Legacy Code>: 3-digit error code previously used for SE 300 system errors
●
<Error Description>: Details about the nature of the error.
●
<Module>: Source object that reported the error.
●
<EID_number>: 5-digit error code that enables CyberOptics personnel to identify the source
location of the error.
Example:
22-May-2009 14:06:34 440 Read Camera Register failed (Middleman: 20507)