CyberOptics SE500ULTRA, Hardware Manual

Page: 16 / 188

Chapter 1 : System Overview
6 SE500
ULTRA
Hardware Manual
SE500
ULTRA
Internal Parts
Opening the hood, which stops all machine motion, gives you access to the sensor, gantry and
conveyor. The lower panel can be removed (by service personnel only) to gain access to internal
electrical components. These parts are described below and shown in Figure 3.
Table 3. SE500
ULTRA
System Internal Components
Component Description
Processor The processor contains two Intel

Xeon

Processor E5-2620 GHz
CPU, one 500GB + one 1 TB hard drives and one DVD +/- R/W drive.
It provides serial, USB, Ethernet, CANOpen, and CameraLink
Framegrabber connections.
Software configuration is Windows XP

Professional, 64-bit platform.
Conveyor The conveyor brings the panel into the machine, clamps it, and
positions it for inspection. During inspection, the gantry moves as
needed in the X and Y directions, and the Z stage adjusts for height
while the panel remains stationary. The conveyor automatically
adjusts to the width of the panel as specified in the SRFF.
Digital I/O Controller The Digital I/O controller uses programmable logic to control
conveyor motion.
Gantry Moves the sensor along the X and Y axes during inspection.
Main Electrical Panel Contains the electronic components needed to power the system
and control motion.
Sensor Measures the height, volume, and area registration, bridging of the
solder pads defined for a given location. The gantry moves along
both the X and Y axes and the Z stage moves the sensor vertically to
keep it in focus.