CyberLink PowerDVD
86
•
PCM decoded by PowerDVD
: this mode creates a digital representation of an
analog signal. Select this option if your external decoder (AV receiver) does not
support Dolby Digital or DTS to produce a digital sounding output for your
audio.
•
Non-decoded Dolby Digital/DTS audio to external device
: this mode passes
compressed audio through to your external decoder (AV receiver). Select this
option if your amplifier/receiver supports Dolby Digital or DTS to enable either
during playback, when available.
•
Non-decoded high-definition audio to external device (HDMI 1.3 only)
: this
mode passes lossless audio through to your external decoder (AV receiver).
Select this option if your amplifier/receiver supports high definition audio to
enable either during playback, when available.
Advanced Audio Settings
On the Audio tab, click
Advanced
to access extra settings for configuring your
playback audio.
Note:
the available advanced audio settings displayed are dependent on the selected
Speaker Environment. See the settings that match your selected environment.
Miscellaneous
This tab is displayed for all selections and allows you to configure audio properties
for DVD-titles equipped with multichannel encoding.
Dynamic range compression
This section only applies to disc titles with Dolby Digital technology.
•
Select the
Quiet Environment
if you are in the mood to watch a movie without
distractions. All audible sound, from low frequency to high frequency audio
effects, will be highly distinctive and fall into the full dynamic range of Dolby
Digital.
•
If your listening environment is not completely adequate to enjoy the full
dynamic range of Dolby Digital, select the
Normal Environment
. Audible
effects that fall in the extreme ranges of Dolby Digital’s audio spectrum will be
compressed.
Summary of Contents for PowerDVD 11
