Installing the VoIP Indoor Intercom
Configure the Intercom Parameters
Operations Guide
930260A
CyberData Corporation
23
3. After changing the parameters, click
Save Settings
.
Authenticate ID*
Enter the
Authenticate ID
(up to 25 alphanumeric
characters).
Authenticate Password*
Enter the
Authenticate Password
(up to 25 alphanumeric
characters).
SIP Registration*
Enable/Disable SIP Registration.
Unregister on Reboot*
• Select
Yes
to automatically unregister the Intercom when
it is rebooted.
• Select
No
to keep the Intercom registered when it is
rebooted.
Register Expiration*
Enter the SIP Registration lease time in minutes (default 60
minutes).
Dial-Out Extension
Enter the button dial-out extension number.
The Dial Out Extension also supports the addition of
comma delimited pauses before sending additional DTMF
tones (using rfc2833). The first comma will pause three
seconds after a call is first established with a remote
device. Subsequent commas will pause for two seconds. A
pause of one second will be sent after each numerical digit.
Examples of Dial-Out Extension strings:
302
: Dial out extension 302 and establish a call.
302,2
: Dial out extension 302 and establish a call. Wait
three seconds and then send the DTMF tone '
2
'.
302,25,,,4,,1
: Dial out extension
302
and establish a call.
Wait 3 seconds and then send the DTMF tone '
2
'. Send out
DTMF tone
5
. Wait six seconds. Send out DTMF tone
4
.
Wait four seconds. Send out DTMF tone
1
.
Note
: The maximum number of total characters in the dial-
out field is 25.
Click this button to save your configuration settings.
Changing a parameter that has an asterisk next to it will
cause a system reboot when saved.
Link to the
Intercom Setup
page.
Link to the
Network Setup
page.
Link to the
Upgrade Firmware
page.
Link to the
Home
page.
Table 2-7. SIP Setup Parameters
Web Page Item
Description
