CyberData Corporation
930260A
Operations Guide
Installing the VoIP Indoor Intercom
Intercom Setup
14
2.2.6.2 Restore the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Each Intercom is delivered with factory set default values. Use the
RTFM
switch on the Intercom
face to restore these parameters to the factory default settings.
To restore the factory default settings:
1. Complete steps
through
Section 2.2.6.1, "Announcing the IP Address"
2. Press and hold the
Call
button for
10
seconds.
3. When you hear the announcement, release the
Call
button. The factory default settings are
restored, and the Interfom will automatically restart.
4. After the Intercom has rebooted, remove the jumper from JP11.
5. Cycle power by disconnecting the PoE cable from J1 and plugging the PoE cable back into J1.
Figure 2-12. RTFM Switch Jumper
2.2.7 Adjust the Volume
You will be only able to adjust the volume through the network configuration page.
