CyberData Singlewire InformaCast Series, Operation Manual, Page: 56 / 91

Installing the Singlewire InformaCast® RGB (Multi-Color) Strobe
Singlewire InformaCast® RGB (Multi-Color) Strobe Setup
Operations Guide 931633A CyberData Corporation
48
Blue The blue LED value for the Sensor.
Use this button to preview the strobe flashing behavior for the
Sensor Strobe Settings .
Intrusion Sensor Settings
Activate Relay When selected, the device's on-board relay will be activated until
the intrusion sensor is deactivated.
Make call to extension When selected, the device will call an extension when the
intrusion sensor is activated. Use the
Dial Out Extension field
below to specify the extension the device will call.
Dial Out Extension Specify the extension the device will call when the intrusion
sensor is activated. Enter up to 64 alphanumeric characters.
Dial Out ID An additional Caller identification string added to outbound calls.
Enter up to 64 alphanumeric characters.
Repeat Intrusion Message The number of times to repeat the audio message to the remote
endpoint. A value of 0 will repeat forever. Enter a value from 0-
65536.
Intrusion Sensor Strobe Settings
Blink Strobe on Intrusion Sensor When selected, the Strobe will blink a scene when the intrusion
sensor is triggered.
Scene Select desired scene (only one may be chosen).
ADA Compliant Strobe will blink ON at the specified brightness for 150ms then
OFF for 350ms during the duration of the event.
Slow Fade Strobe will increase in brightness from 0 to the specified
brightness and back to 0 over the course of about 3.5 seconds
during the duration of the event.
Fast Fade Strobe will increase in brightness from 0 to the specified
brightness and back to 0 over the course of about 1.5 seconds
during the duration of the event.
Slow Blink Strobe will blink ON at the specified brightness for one second
then OFF for one second during the duration of the event.
Fast Blink Strobe will blink ON at the specified brightness then OFF five
times per second during the duration of the event.
Color Select desired color (only one may be chosen).
Brightness How bright the strobe will blink when the intrusion sensor is
triggered. This is the maximum brightness for “fade” type scenes.
Red The red LED value for the Intrusion Sensor.
Green The green LED value for the Intrusion Sensor.
Blue The blue LED value for the Intrusion Sensor.
Use this button to preview the strobe flashing behavior for the
Intrusion Sensor Strobe Settings .
Table 2-14. Sensor Configuration Parameters (continued)
Web Page Item Description