Installing the Singlewire InformaCast® RGB (Multi-Color) Strobe
Singlewire InformaCast® RGB (Multi-Color) Strobe Setup
Operations Guide
931633A
CyberData Corporation
17
2.3 Configure the Singlewire InformaCast® RGB (Multi-
Color) Strobe Parameters
To configure the Singlewire InformaCast® RGB (Multi-Color) Strobe online, use a standard web
browser.
Configure each Singlewire InformaCast® RGB (Multi-Color) Strobe and verify its operation
before
you mount it. When you are ready to mount an Singlewire InformaCast® RGB (Multi-Color) Strobe,
refer to
Appendix A, "Mounting the Singlewire InformaCast® RGB (Multi-Color) Strobe"
for instructions.
2.3.1 Factory Default Settings
All Singlewire InformaCast® RGB (Multi-Color) Strobes are initially configured with the following
default IP settings:
When configuring more than one Singlewire InformaCast® RGB (Multi-Color) Strobe, attach the
Singlewire InformaCast® RGB (Multi-Color) Strobes to the network and configure one at a time to
avoid IP address conflicts.
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
10.10.10.10
Web Access Username
admin
Web Access Password
admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
Table 2-6. Factory Default Settings
a. Default if there is not a DHCP server present.
