Installing the Singlewire InformaCast® RGB (Multi-Color) Strobe
Singlewire InformaCast® RGB (Multi-Color) Strobe Setup
Operations Guide
931633A
CyberData Corporation
9
2.2.2 Connecting the Singlewire InformaCast® RGB (Multi-Color) Strobe to
the On-Board Relay
The device incorporates an on-board relay which enables users to control an external relay for
activating an auxiliary device such as an electric door strike (see
Figure 2.2.3, "Identifying the
Singlewire InformaCast® RGB (Multi-Color) Strobe Connectors and Jumpers
The relay contacts are limited to 1A at 30 VDC. The relay activation time is selectable through the
web interface and is controlled by DTMF tones generated from the phone being called. The DTMF
tones are selectable from the web interface as well.
Warning
Electrical Hazard:
The device enclosure is not rated for any AC voltages.
Warning
Electrical Hazard:
This product should be installed by a licensed electrician
according to all local electrical and building codes.
Warning
Electrical Hazard:
To prevent injury, this apparatus must be securely attached
to the floor/wall in accordance with the installation instructions.
Warning
Electrical Hazard:
The relay contacts are dry and provided for a normally
open and momentarily closed configuration. Neither the alternate power input
nor PoE power can be used to drive a door strike.
Warning
The PoE connector is intended for intra-building connections only and does not
route to the outside plant.
GENERAL ALERT
GENERAL ALERT
GENERAL ALERT
GENERAL ALERT
GENERAL ALERT
