Installing the Singlewire InformaCast Indoor Intercom with Keypad
Configure the Device
Operations Guide
931640A
CyberData Corporation
37
Auto-Answer Incoming Calls
When selected, the device will automatically answer incoming calls. When
Auto-Answer Incoming Calls is disabled, the device will play a ring tone
(corresponds to Ring Tone on the Audiofiles page) out of the speaker until
someone presses the Call button to answer the call or the caller
disconnects before the call can be answered.
Button Lit When Idle
When selected, the Call button LED is illuminated while the device is idle
(a call is not in progress).
Button Brightness (0-255)
The desired Call button LED brightness level. Acceptable values are 0-
255, where 0 is the dimmest and 255 is the brightest. Enter up to three
digits.
Keypad Lit When Idle
When selected, the keypad is illuminated while the device is idle (a call is
not in progress).
Keypad Brightness (0-255)
The desired keypad brightness level. Acceptable values are 0-255, where
0 is the dimmest and 255 is the brightest. Enter up to three digits.
Play Ringback Tone
When selected, the device will play a ringback tone (corresponds to
Ringback Tone on the Audiofiles page) out of the speaker while placing an
outbound call. The Ringback Tone will play until the call is answered.
Enable Push to Talk
This option is for noisy environments. When enabled, the microphone will
be muted normally. When the Call button is pressed and held, it will
unmute the microphone and allow the operator to send audio back. Using
Push to Talk prevents the operator from terminating a call by pressing the
Call button. The call must be terminated by the phone user.
Enable DTMF Push to Talk
This option is for noisy environments. When enabled, in an active call, the
remote phone can force receive only audio (setting the mic gain to max
and muting the speaker) by pressing the
*
key.
Pressing the
#
key will force send only audio (setting the max speaker
volume and muting the mic). Pressing the
0
key will restore full duplex
operation with the normal microphone and speaker volume.
Prevent Call Termination
When this option is enabled, a call cannot be terminated using the call
button.
Disable HTTPS (NOT recommended)
Disables the encrypted connection to the webpage. We do not
recommend disabling HTTPS for security reasons.
Note
This setting requires a reboot for the changes to take effect.
Singlewire Broadcast Strobe Settings
For up to 10 Singlewire pages, when a priority is specified for the page, a
corresponding strobe scene will be activated. The color may be selected
from the drop down menu, or customized by the user with the 0-255 scale.
Brightness is specified with a value between 0 and 255.
The following strobe settings will only appear if a CyberData Strobe
product is connected to your device. If a CyberData Strobe product
is not connected to your device, you will not see the strobe settings.
Priority
Indicates the priority of the Singlewire broadcast, with 1 the highest
priority and 10 the lowest.
Scene
Use this section to select the strobe flashing behavior for the Singlewire
Broadcast.
ADA Compliant
Strobe will blink ON at the specified brightness for 150ms then OFF for
350ms during the duration of the event.
Table 2-8. Device Configuration Parameters (continued)
Web Page Item
Description
