Quick Reference
931560F
© 2022, CyberData Corporation, ALL RIGHTS RESERVED
© 2022, CyberData Corporation, ALL RIGHTS RESERVED
931560F
Quick Reference
Gooseneck Mounting
Contacting CyberData
Ground Wire
Network Cable
(Sold separately)
Weather Shroud
Backbox
Torx security screw
Faceplate mounting
Torx key
SIP Outdoor Intercom with Keypad
(4 sets included)
Carriage Bolt
Gooseneck
Cable & Wire
Create service loop
Apply RTV Silicone Sealant around mounting holes and
backside perimeter of Backbox and Weather Shroud
Carriage Bolt, Washer & Nut
(All Cables, Fasteners, Sealant and Gooseneck are not provided
(Apply Blue Loctite on threads)
unless noted otherwise.)
J1
to J1
GENERAL ALERT
Caution
Equipment Hazard:
Do not use an electric
or power screwdriver to fasten the face plate
and PCB assembly to the gang box. To prevent
over-torque damage to the gasket, do not apply
more than 10 inch-pounds force. Over-torquing
will cause the gasket to tear, risk moisture intrusion,
and effectively void the manufacturer's warranty.
Note
: To mount the intercom, use methods
compliant with local electrical codes.
Note
: More installation and mounting
information is illustrated in the Operations Guide.
011215 Outdoor Shroud, 2X
Sales: 831-373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website:
https://support.cyberdata.net/
RMA Department Contact and Status:
https://support.cyberdata.net/
Warranty Information:
https://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
Typical System Installation
Getting Started
•
Download the
Operations Guide
PDF file, from the
Downloads
tab at the following webpage:
https://www.cyberdata.net/products/011214
•
Create a plan for the locations of your devices.
•
WARNING: This product should be installed by a licensed electrician according to all local electrical and building codes.
•
WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation
instructions.
•
WARNING: The PoE connector is intended for intra-building connections only and does not route to the outside plant.
•
WARNING: This enclosure is not rated for any AC voltages!
Parts
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
IPv4 Link Local
Web Access Username
admin
Web Access Password
admin
Subnet Mask
a
IPv4 Link Local
Default Gateway
a
IPv4 Link Local
a. Default if there is not a DHCP server present.
802.3af Compliant Ethernet Switch
Intercom
IP Phone
IP PBX Server
Intercom
Intercom
*
More installation and mounting
options are available in the
Operations Guide
.
Accessory Kit
Mounting Component
(1) 1/2-inch EMT
compression
connector with extra
sealing locknut
(1) 531085* Hole
plug assembly
(4) Carriage bolts
(4) Carriage bolt nuts
(4) Carriage bolt washers
(6) Security Torx Screws
Security Torx Key
(6) Phillips Screws
Optional Accessories
(for gooseneck mounting)
Optional Accessories
Sold Separately
Installation Quick Reference
SIP Outdoor Intercom with Keypad
SIP Compliant
011214
The IP Endpoint Company