CYBELEC CybTouch 12PS, User Manual

Page: 60 / 64

User Manual – CybTouch series
CybTouch Series – User Manual
J
AN
.
2020
V5.0
59/63
M
SG
N
R
. M
ESSAGE
D
ESCRIPTION
E87 Unknown error An unknown error occurred while trying to program an option.
Contact Cybelec.
E88 RS232: port already open
E89 Solution not found This message indicates that the bending sequence automatic search
did not find any solution. Try to create the bending sequence
manually. If not possible, it means that this part is not feasible on
this machine.
E90 Too many buttons on bend num
page Too many buttons are configured for the available space on the
Bend Numerical Page . The last one, and all the following will be
refused. A technician must check the configuration.
E91 Next program error This message appears when there has been a problem with the
Next-Part Function . The problem appeared when going to the next
part: it doesn’t exist or could not be read.
E92 Step bending-too many steps The programmed step-bend cannot have so many steps. Try
reprogramming it, and eventually the whole part.
E93 Beam drive error There is an error on one of the drives controlling the beam. Check
them and resolve the problem. They must be ready to run.
E94 F_CycStopAxe failure, please
make a “Tracer”
Should not happen. If it does, call a technician to make a trace and
have him send it to
support@cybelec.ch .
E95 Combined machine IO
configuration (Option K1 - combined machine) – configuration of the outputs/
inputs is not correct when option K1 is activated.
E97 Negative face length Flange length is too short for the radius programmed.
E98 Incorrect face This message means that the face number programmed in the bend
sequence is outside the limits. This message can normally not
happen on a part programmed on the CybTouch but could on an
imported part. Reprogram the part entirely.
E99 Illegal stop This message means that there is a problem between the stop
number and the face number programmed in the bend sequence.
One or the other is outside the limits. This message can normally
not happen on a part programmed on the CybTouch but could on an
imported part. Reprogram the part entirely.
E100 Stop does not suit No gauging solution was found for the current bend. This bend
cannot be made with the actual machine configuration.
E101 Station error (Option K1 - combined machine) – this message is displayed when
trying to go in auto mode, and no station is defined. Or if one of the
switches defining the current station changes state while working.
E102 Cycle station Time out (Option K1 - combined machine) – the duration of the station
change cycle exceeded the maximum allowed. Check if the station
movement is not impeded in any way.
E103 Clamping opened The machine cannot start if the tools are not properly clamped.
Check the status of the tools on page
Manual Axes Movement .
E104 Station locked (Option K1 - combined machine) – it is not possible to work on the
station, because the tooling is still locked (input Unlocked not
active). Check the locking device of the station.
E105 Cylinder not in position (Option K1 - combined machine) – the station cannot change
position, because one of the cylinder’s status is unknown, i.e. it is
neither closed nor opened. Correct the situation from the page
Manual Axes Movement.